We are still working to obtain content for your car, however the video above is believed to have similar characteristics as your car. Tweet Video Description A check engine light can indicate a broad spectrum of problems with your Dodge Neon. In some cases you need to pull over immediately to prevent damage while in others you merely need to tighten you gas cap next time you stop in order to reset the service engine soon light. The video above shows how to locate the on board diagnostics OBD plug on your Neon, how to read the trouble codes and how to reset or clear the check engine light using a scanner on your Neon.

Intermittent Check Engine Light: If the check engine light on your Neon is intermittent, try to take note of the conditions when this happens.

NEON 24V LED Stri Light INSTALLATION GUIDE Input 24VDC Constant Voltage Do not use if there is any damage to the fixture or wiring. Inspect periodically. 5. Do not submerge Strip Light in liquids or use the product in the vicinity of standing water or other liquids. 6. Do not install near areas with exposure to chlorinated water.

Although it operates at V, 50 Hz, some auxiliary electrical components are used to insert in this installation to support the tube light operational principle. The total electrical components for single tube light installation are Choke: Small neon glow up lamp Switch Wiring Diagram of Single Tube Light Installation with Electromagnetic Ballast How to Install a Single Tube Light with Electromagnetic Ballast From the junction box the neutral wire is not taken out to the switch board, rather it is taken out from the junction box and carried out to the port 2 of the tube light, as per figure above.

A wire already connects port 2 and pin 1 of the terminal 2. So the neutral wire is continued from port 2 to pin 1 of terminal 2. The live wire or phase is taken from the junction box to the switch board. The live wire is connected to the one terminal of the switch.